Colin's Radio Control

Dragonfly 2

Smaller version of Dragonfly with upgraded & 3D printed parts.

 

Type Tricopter Home made
Receiver LemonRX 6 channel
 Ch 1 Roll  
 Ch 2 Pitch  
 Ch 3 Lift  
 Ch 4 Yaw  
 Ch 5 Mode Acro / Self-Levelling / Self-Levelling Mix
 Ch 6 Lights  
Flight Controller KK 2.1.5 Hard Case  
Battery 3S LiPo  
Motors FC 2822  1200kv  
Circumdiameter    
Takeoff Weight    

 

Dragonfly 2 - construction started

I have started building a second Dragonfly tri-copter.

Dragonfly 2 will be smaller than the original Dragonfly as the spars are made from old cutoffs.  The motor mounts and tail assembly are 3D printed (thanks Bill for the printing!).

Dragonfly 2 - Construction phase 01
 
 The video below shows a servo test of the tail assembly.  The motor has been left off so that the servo & linkage can be seen clearly.
 
 
Follow on Facebook Follow on Twitter Follow on Youtube